WatchUSeek Watch Forums banner

PRG 260 on bracelet

Tags
prg 260
829 views 13 replies 8 participants last post by  GTR83 
#1 · (Edited)
#10 · (Edited)
Well it wasn't. To make it fit, I had to make the strap's shoulders narrower and deeper, also those cuts must be made in an angle otherwise there will be a singificant gap between the strap and the watch's "wings". Get a sharp knife and a steady hand, and start with very small cuts. After all it's not too difficult just be very careful.
 
#12 ·
Its 24mm at the place where it connects to the watch and goes down to 20mm at the clasp.
You can cut it down to the right size. The bracelet is made from a kind of plastic, can be cut with a knife. Compared to the price of the titanium, it would worth a try.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top