I have not worn my AT for perhaps two months. It has been on a watch winder during those two months. It seemed fine last time I recall. However, I just took it off and it was dead. I am newbie, but I believe I am winding it properly.
I unscrew the crown and you can feel it slide over a notch, without actually pulling it. I wound it there clockwise.
It sometimes starts to work, then stops. If I shake it, same thing. If I wear it, same thing. Will run 3-4 seconds then stop. I wore it for about 30 minutes, and it move about 20 seconds in that time. But then dead again.
I thought you could not over wind these, but also if you did wind it it would start up. I am now worried something has happened. I did remove the watch last week briefly from the watch winder, now I am thinking perhaps I did not screw the crown down properly and then placed it back on?
In any event, wondering what might be wrong or if I am doing something wrong. I put it back on the watch winder. Seems to have moved another 2 seconds in the last two turns on the winder. But still dead. Thank you.