just received the bracelet today
so here goes another round
a watch case holder would be useful in this case but not a necessity
hold one flat screwdriver against the screw on one side and the case and use another screwdriver to unscrew
push out the pin
place the adapter to the case
insert the washer (???) into the bracelet
insert the pins and screw it back
adjust the length of the bracelet. the tool is too big so i switch to a 1.4mm flat screwdriver. just like changing a strap, press down and press out.
only one side of this pin squeezable, so place the rigid side on the "bottom" where the arrow head is
like my orange strap as it is, so changed the 3000BB instead
on a side note, the pins were too long, not sure if they have a shorter pin.