Bought a new Milanese mesh for my Orca.. unfortunately I had to remove every pin link, bar 1. Why canít they all be screws!
well Iím impatient and sure I had some tools lying around.
well first attempt with the pin removal machine and I didnít line it up properly and snap. Whoops.
Then I remembered I have a handheld one... just have to line it up. Use the base or two book for balance, and use an ice cream scoop to hammer out. Bingo in luck
Got a few done then ... ping , snap . Then I found another smaller metal tool still wrapped up. This got the rest done with some help from nail clippers and a metal ice cream scoop as hammer
The first time time I got sized right I had the clasp folded on the wrong side.. well off it comes again.
Only took and hour, and a lot of swearing but was worth it I reckon